I am in need of some organization as this is what my ribbon container looks like…
Plus I cleaned it up a little – haha This is how I did it…
- Messy ribbon box
- Plastic container with holes
- Pile wood rode (need to measure the hole of the basket)
Step 1: Measure how long the rod needs to be. I had my stick out about 2 cm.
Step 2: Saw
Step 3: Do the same to the 2nd rod
Step 4: Stick the 1st rod through 1/4 of the way
Step 5: Start threading the ribbons on.
Step 6: When you get the last one. Stick through the other end. It should look like the above picture.
Step 7: Pull the ribbons through the holes.Step 8: Do the same to the 2nd Rod.
Because I could fit more ribbons on the rod then there were holes, I used the bottom row as well.
Looks cool huh??